If you have any additional ideas or experience with self-hosting behind AT&T Fiber, let me know! I'm just happy to be paying half as much as I was for Charter/Spectrum coax, but getting more than 20x faster upload speeds :) My Raspberry Pi running Wireguard / PiVPN now gives me about 300 Mbps up and down (was previously limited to 35 Mbps up and down due to the slow upload speed on Spectrum!).Will continue monitoring my Internet connection with my Raspberry Pi to see if that changes over time. Currently I'm only measuring 550 Mbps down and 650 Mbps up, tested via 10 Gbps internal LAN and WiFi 6E network right next to my AP.I was paying $135/month for 1 Gbps down, 40 Mbps up with Spectrum. I'm paying $80/month for 1 Gbps symmetric speed now.The whole install for a house that never had fiber took about 2.5 hours (friends in the neighborhood say it varied between 1-3 hours, depending on the complexity of the install).When they do the install, the tech seems to do the 'cable from the box to your house to your gateway location' install, but if you have buried cable, another crew comes later to bury the actual fiber outside the house.In the future, I may tweak settings a bit more if I find the AT&T Gateway device interfering with performance much (it seems to have its own layers of packet filtering and firewall that may still be touching the packets.). I saved those changes, and immediately had Internet through my existing router, and checked, grabbed the IP, ran it through traceroute to confirm there wasn't any extra NAT layer anymore, and then set that IP for all my self-hosted services, like my self-hosted PiVPN instance and my Raspberry Pi Dramble website. I wanted the IP address AT&T assigns (which is dynamic unless you add on Static IP addresses starting at $15/month) to be passed through to my own router, so I went to Firewall > IP Passthrough, then I set 'Allocation Mode' to 'Passthrough', 'Passthrough Mode' to 'DHCPS-fixed', and then pasted in the MAC address of my existing router WAN interface. Instead, I plugged the blue 5 Gbps port into my router's WAN port, and logged into the BGW320-500's admin UI (which is available at ). which unfortunately is used for the fiber connection, so I couldn't just use a DAC between my router and this box. The AT&T tech (who was great!) installed an NBS AT&T BGW-320 500 Fiber Gateway, and on the back I spied an SFP port. ![]() It seems like they have little fiber hubs for 8 houses in a set, and those little hubs connect back to the main neighborhood box with an 8 or 10-strand cable, directly buried in the ground.Īpparently my street's main run was kinked somewhere, and only one of the strands had full signal, so I'm the lucky winner who signed up first, and I get that fiber until they run a new cable underground :) ![]() They trenched fiber boxes between pairs of houses in my neighborhood. Today I got AT&T Fiber Internet installed at my house, and I thought I'd document a few things I observed during and after the install.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |